Sirona CEREC SpeedFire - Positioning the Door Insulation

65 71 165 D3639
30 D3639.201.01.02.02 10.2016
4Transport and commissioning Sirona Dental Systems GmbH
4.6Commissioning Operating Instructions CEREC SpeedFire
4.6.3 Positioning the door insulation
Fragment: CAUTION Handling and disposing of the insulating material
1. Insert the positioning pin into the hole of the furnace door.
2. Start by placing the bottom door insulation on the positioning pin.
CAUTION
Handling and disposing of the insulating material
Abrasion of insulating material in the furnace door area may occur,
which is visible as white dust. These deposits should:
- be wiped off with a moist cloth or
- be extracted with a vacuum cleaner with a fine particle filter (e.g. HEPA
/ Dust category H),
- not be blown away with compressed air,
- not be blown away by the wind.
Direct skin contact may lead to skin irritation. Please therefore avoid
contact with the skin and eyes and wear gloves and safety goggles as
necessary. In the event of contact with the skin wash the dust of the
insulating material off with clear running water.
Always dispose of the insulating material in a closed container (see also
"Disposal [ → 52]").
CAUTION
The unit must not be operated without door insulation.