Sirona CEREC SpeedFire - 6 Care and Maintenance; Insulation Material of the Furnace Chamber

65 71 165 D3639
D3639.201.01.02.02 10.2016
47
Sirona Dental Systems GmbH 6Care and maintenance
Operating Instructions CEREC SpeedFire 6.1Insulation material of the furnace chamber
båÖäáëÜ
6
Care and maintenance
6.1
Insulation material of the furnace chamber
Fragment: CAUTION Handling and disposing of the insulating material
Fragment NOTE IN THE OPERATING INSTRUCTIONS
Please also observe the information provided under “Positioning the door
insulation [ → 30]”.
CAUTION
Handling and disposing of the insulating material
Abrasion of insulating material in the furnace door area may occur,
which is visible as white dust. These deposits should:
- be wiped off with a moist cloth or
- be extracted with a vacuum cleaner with a fine particle filter (e.g. HEPA
/ Dust category H),
- not be blown away with compressed air,
- not be blown away by the wind.
Direct skin contact may lead to skin irritation. Please therefore avoid
contact with the skin and eyes and wear gloves and safety goggles as
necessary. In the event of contact with the skin wash the dust of the
insulating material off with clear running water.
Always dispose of the insulating material in a closed container (see also
"Disposal [ → 52]").