SKF MAX-1-2-230-IF105-R-V2 Assembly Instructions

3
Original EC Declaration of Incorporation in accordance with Directive 2006/42/EC,
Appendix II Part 1 B
The manufacturer hereby declares at its sole responsibility that the partly completed machinery conforms to the essential health and safety
requirements of the Machinery Directive 2006/42/EC, Annex I, marked in the Annex to the EC Declaration of Incorporation as applicable and
fulfilled at the time of placing on the market.
The special technical documents were prepared following Annex VII part B. Upon justifiable request, these special technical documents can be
forwarded electronically to the respective national authorities. The authorized company for the compilation of the technical documentation is the
manufacturer.
Designation:
Changeover valve unit
Type
SKF Maxilube MAX-X-X-24-X-X-X
Furthermore, the following directives and standards were applied in the respective applicable areas:
2011/65/EU: ROHS II including the addition (EU) 2015/863
EN ISO 12100-1/A1 EN ISO 12100-2/A1
The partly completed machinery must not be put into service until it has been established that the machinery into which it is to be incorporated is
in compliance with the provisions of the Machinery Directive 2006/42/EC and all other applicable Directives.
Muurame, 24.5.2022
Juha Kärkkäinen
Design Office Manager
SKF Lubrication Management
Manufacturer: Oy SKF Ab Finland Teollisuustie 6 40951 Muurame FINLAND
Original UK Declaration of incorporation according to the Supply of Machinery (Safety)
Regulations 2008 No. 1597 Annex II
The manufacturer hereby declares under sole responsibility that the partly completed machinery complies with the essential health and safety
requirements of UK legislation Supply of Machinery (Safety) Regulations 2008 No. 1597 Annex I, marked in the Annex to the EC Declaration of
Incorporation as applicable and fulfilled at the time of placing on the market.
The special technical documents were prepared following Annex VII part B. Upon justifiable request, these special technical documents can be
forwarded electronically to the respective national authorities. The authorized company for the compilation of the technical documentation is
SKF (U.K.) Limited, 2 Canada Close, Banbury, Oxfordshire, OX16 2RT, GBR.
Designation:
Changeover valve unit
Type
SKF Maxilube MAX-X-X-24-X-X-X
Furthermore, the following regulations and standards were applied in the respective applicable areas:
• The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012 No. 3032
EN ISO 12100-1/A1 EN ISO 12100-2/A1
The partly completed machinery must not be put into service until it has been established that the machinery into which it is to be incorporated is
in compliance with the provisions of UK legislation Supply of Machinery (Safety) Regulations 2008 No. 1597 and all other applicable Directives.
Muurame, 24.5.2022
Juha Kärkkäinen
Design Office Manager
SKF Lubrication Management
Manufacturer: Oy SKF Ab Finland Teollisuustie 6 40951 Muurame

SKF MAX-1-2-230-IF105-R-V2 Specifications

General

Brand	SKF
Model	MAX-1-2-230-IF105-R-V2
Category	Water Pump
Language	English