Skyjack SJ46 AJ+ - 13 No Jib up - CE & as; 14 No Jib down - ANSI;CSA

185
229042ABASJ46 AJ+, SJ46 AJ, SJ51 AJ
Hydraulic System Section 4 – Troubleshooting Information
4.5-13 No Jib Up - CE & AS
1. Stuck or defective jib enable valve 2H-34A. Clean valve. Check O-rings on valve. Check
operation of valve. Repair or replace valve as
required.
2. Plugged or defective orifice OR2. Check orifice. Replace if plugged or defective.
3. Stuck or defective differential pressure sensing
valve DSV5.
Clean valve. Check O-rings on valve. Check
operation of valve. Repair or replace valve as
required.
4. Stuck or defective check valve CV12. Clean valve. Check operation of valve. Repair or
replace valve as required.
5. Stuck or defective jib up valve 4H-35. Clean valve. Check operation of valve. Repair or
replace valve as required.
6. Stuck or defective counterbalance valve CB12. Clean valve. Check O-rings on valve. Repair or
replace valve as required.
7. Defective jib cylinder C1. Check seals on cylinder. Replace as necessary.
Replace cylinder if defective.
4.5-14 No Jib Down - ANSI/CSA
1. Stuck or defective jib enable valve 2H-42. Clean valve. Check O-rings on valve. Check
operation of valve. Repair or replace valve as
required.
2. Stuck or defective differential pressure sensing
valve DSV5.
Clean valve. Check O-rings on valve. Check
operation of valve. Repair or replace valve as
required.
3. Stuck or defective check valve CV12. Clean valve. Check operation of valve. Repair or
replace valve as required.
4. Stuck or defective jib down valve 4H-34. Clean valve. Check operation of valve. Repair or
replace valve as required.
5. Stuck or defective counterbalance valve CB13. Clean valve. Check O-rings on valve. Repair or
replace valve as required.
6. Defective jib cylinder C1. Check seals on cylinder. Replace as necessary.
Replace cylinder if defective.
To order go to Discount-Equipment.com