EasyManuals Logo

Skyjack SJ46 AJ+ Service Manual

Skyjack SJ46 AJ+
276 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #204 background imageLoading...
Page #204 background image
207
229042ABASJ46 AJ+, SJ46 AJ, SJ51 AJ
Platform Section 5 – Procedures
Pin 10 - 12 volt output on wire 26 brake valve 3H-26. 12V=Drive selected
Test between pin 10 and 02 wire.
Pin 11- 12 volt output on wire 27 to tilt alarm relay 27CR.
Test between pin 11 and 02 wire
Pin 12 - Riser down selected. Proportional output on wire 30 to riser down valve 5H-30.
0 volts to 4.3 volts depending on position of joystick. Threshold= 2.8 volts.
Test between pin 12 and 02 wire.
Pin 13 - 12 volt input from wire 4.
Test between pin 13 and 02 wire.
Pin 14 - Variable input from wire 128A.
1 Volt to 5 volts depending on angle of machine
1 volt = Level
Test between pin 14 and 02 wire
Pin 15 - Turret position. 12 volt input from limit switch LS1 on wire 17.
0 volts= Platform over drive axle.
12 volts= Platform over steer axle.
Test between 15 and 02 wire.
Pin 16 - Foot switch activated. 12 volt input from wire 08A.
Test between pin 16 and 02 wire.
Pin 17 - Left steer selected. 12 volt input from wire 24.
Test between pin 17 and 02 wire.
Pin 18 - Right steer selected. 12 volt input from wire 23.
Test between pin 18 and 02 wire.
Pin 19 - 12 Volt output on wire 26A to differential lock switch. 12V= Footswitch activated.
Test between pin 19 and 02 wire.
Pin 20 - Turret rotate left selected. Proportional output on wire 32 to turret rotate left valve 5H-32.
0 volts to 6.0 volts depending on position of joystick. Threshold= 3.5 volts.
Test between pin 20 and 02 wire while operating turret rotate left.
Pin 21 - 12 Volt output on wire 23A to right steer valve 5H-23A
Test between pin 21 and 02 wire.
Pin 22 - Boom up selected. Proportional output on wire 14 to boom up valve 5H-14.
0 volts to 6.5 volts depending on joystick position. Threshold= 3.2 volts.
Test between pin 22 and 02 wire while operating boom up.
Pin 23 - Reverse drive selected. Proportional output on wire 15 to reverse drive valve 4H-15.
0 volts to 5.5 volts depending on joystick position. Threshold= 1.1 volts.
Test between pin 23 and 02 wire while operating reverse drive.
To order go to Discount-Equipment.com

Table of Contents

Other manuals for Skyjack SJ46 AJ+

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Skyjack SJ46 AJ+ and is the answer not in the manual?

Skyjack SJ46 AJ+ Specifications

General IconGeneral
BrandSkyjack
ModelSJ46 AJ+
CategoryBoom Lifts
LanguageEnglish

Related product manuals