SkyWave IDP-782 - Page 6

IDP-782 - Hardware Guide
4.3.3 Determine Terminal Orientation for Accelerometer Use 57
4.4 Mount the Antennas 58
4.4.1 Screw Mount 58
4.4.2 Adhesive Mount 59
4.4.2.1 Silicone Side Connector Mount 59
4.4.2.2 Silicone Bottom Connector Mount 60
4.4.3 Cellular Antenna 63
4.5 Route the Main Cable 64
4.5.1 Protect the Cables and Cable Connectors 64
4.6 Connect to Power 65
4.6.1 CAN bus Connection 66
4.7 Connect the Cables and Mount the Terminal 66
4.7.1 Terminals without a Terminal Shroud 66
4.7.2 Terminals with a Terminal Shroud 69
4.7.3 Disconnect the FAKRA Connector 74
4.8 Register the Terminal 74
4.9 Application Programming Interface 74
4.10 Cleaning Instructions 75
5 Troubleshooting the Terminal 76
5.1 Terminal Does Not Register or Report 76
APPENDIXA Order Part Numbers 77
APPENDIXB Activation Information 78
APPENDIXC Satellite Antenna Dimensions 79
APPENDIXD Terminal Shroud 80
APPENDIXE Remove the FAKRA Housing for Cable Installation (optional) 81
APPENDIXF Mating Cable Assembly Instructions 82
Mating Connector and Terminal Pins Part Numbers 82
Electrical Pin Assignments 82
Cable Selection 83
Acronyms/Glossary 85
Revision History 87
T213, Version 02
6
© SkyWave Proprietary