IDP-782 - Hardware Guide
Figure 30: Accelerometer and Terminal Orientation 58
Figure 31: Apply Silicone to Antenna 60
Figure 32: Weight on the Antenna 60
Figure 33: Drill Mounting Hole 61
Figure 34: Attach Cable to Terminal 61
Figure 35: Apply Silicone to Hole in Asset 62
Figure 36: Apply Silicone to Terminal 62
Figure 37: Weight on the Antenna 63
Figure 38: Sample Cellular Mounting Locations – automobile example 63
Figure 39: Sample Cable Placement in a Vehicle Cab 64
Figure 40: Cable Management 65
Figure 41: Connect the Satellite Antenna 67
Figure 42: Connect the Cellular Antenna 67
Figure 43: Connect the I/O Power Cable 68
Figure 44: Mounting Flange 68
Figure 45: Cut Tip of RF Cable Portion 69
Figure 46: Disassemble the FAKRA Connector 69
Figure 47: RF Cable through the Terminal Shroud Opening 70
Figure 48: I/O Cable through the Terminal Shroud Opening 70
Figure 49: Connect the Connectors to the Terminal 71
Figure 50: Terminal in Shroud 71
Figure 51: Apply Silicone 72
Figure 52: Reset Button 72
Figure 53: Cable Ties and Silicone 73
Figure 54: Mounting Slot Indicators 73
Figure 55: Apply Silicone to Hardware 73
Figure 56: Disconnecting the FAKRA Connector from the Transceiver Unit 74
Figure 57: Terminal Shroud 80
Figure 58: Locking Clip and Plastic Housing 81
Figure 59: Cable without Housing 81
T213, Version 02
8
© SkyWave Proprietary
To Next Page
Loading...
