8. Slide machine into desired position, then left legs, one or two at a time, to
remove towel(s).
9. Attach the steam and hot water handles by threading into place.
10. Pull the steam actuator forward, into the “on” position.
‣
Leave steam actuator in the “on” position for “Step 9: Turn on Heating
Elements”.
Step 3: Connect Drain Hose
Parts and tools:
•
Drain hose (included)
•
Hose clamp (included)
•
Flat-head screwdriver
Procedure:
1. Use the hose clamp to fasten the drain hose to the drain outlet, as shown
below.
‣
The drain hose has an inside diameter of 5/8" (1.6cm).
2. Prevent clogging by ensuring that the drain line always goes downwards.
‣
Leave steam actuator in the “on” position for “Step 9: Turn on Heating
Elements”.!
To Next Page
Loading...
