Slayer Single Group User Manual

Step 4: Connect Water Line
IMPORTANT: Before connecting a water treatment system to your espresso
machine, rinse the system by running water through it for at least two (2) minutes.
Failure to follow this step will result in equipment damage. Read the Water
Treatment Requirements on page 6 for information about avoiding and addressing
water-related issues.
Parts and tools:
•
60”x3/8” braided stainless steel hose
•
Wrench
Procedure:
1. Connect water treatment system to main water line.
2. Use a braided stainless steel hose to connect the water treatment system
outlet to the espresso machine water inlet (located at the bottom-rear of the
machine); tighten with a wrench.
‣
The end with the 90-degree fitting should connect to the espresso
machine.
‣
Leave steam actuator in the “on” position for “Step 9: Turn on Heating
Elements”.
Step 5: Connect Machine to Power
Your espresso machine will ship with the power configuration requested at the time
of purchase. Machines designated for 110 volts will arrive with a plug attached to
the power cord; machines designated for 220 volts will not. Only an electrician or
approved technician should wire the power cord into an appropriately-rated plug
end.
1. Per previous steps, ensure that the steam actuator is pulled forward, into the
“on” position, and the drain hose and water line are connected.
2. After attaching a plug end (if applicable), insert the main power cord into an
appropriately-rated and grounded receptacle.
‣
Once connected to power, the machine will automatically turn on, the
display will read “INITIALIZING”, and the tanks will begin to fill.
‣
Leave steam actuator in the “on” position for “Step 9: Turn on Heating
Elements”.
Step 6: Fill Tanks
Per “Step 5: Connect Machine to Power”, tanks will automatically begin to fill once
the machine is connected to power. While filling, the screen will display an upward-
facing arrow (“⇑”). Filling is complete when the pump motor ceases to work and a
“click” is heard. Wait to turn on the heating elements until instructed to do so in
“Step 10: Turn On Heating Elements”.
13

Slayer Single Group Specifications

General

Boiler Type	Dual Boiler
Brew Temperature Control	PID
Groups	1
Pre-infusion	Programmable
Voltage	110V/220V
Water Source	Plumbed or Reservoir
Pump Type	Rotary