2. Swipe from right to left until the “Advanced Setting” sub-menu comes into
view.
3. Tap the round touch sensor to enter the “Advanced Setting” sub-menu.
Disable Touch?
The touch sensors can be temporarily disabled for safe cleaning of the glass
screen. After completing the steps above to access the “Advanced Setting” sub-
menu, disable touch with the following steps.
1. When the display reads, “Disable Touch? Enter to Start”, tap the round
touch sensor to begin the “Disable touch” program.
2. The display will read, “Touch Disabled” and a timer will count down from
20 seconds. The remaining duration of the program will be indicated by
“Enable in: x”, where x represents the seconds until completion.
‣
To cancel the program before it has finished and exit “Advanced
Setting” sub-menu navigation, move the brew actuator to the “pre-
brew” or “full brew” position.
3. Once the program has finished, the original query, “Disable Touch? Enter
to Start”, will reappear. To continue “Advanced Setting” sub-menu
navigation, swipe from left to right. To exit menu navigation, move the
brew actuator to the “pre-brew” or “full brew” position.
Bleed Group
An automated bleeding program is used to force trapped air from the group.
While not typically required, this program may resolve stalling during pre-brew.
After completing the steps above to access the “Advanced Setting” sub-menu,
begin the “Bleed Group” program with the following steps.
1. Swipe from left to right until the “Bleed Group” program comes into view.
2. When the display reads, “Bleed Group OK = Begin”, tap the round touch
sensor to begin the “Bleed Group” program.
3. The display will read, “Bleed Group” and a timer will count down from 10
seconds. The remaining duration of the program will be indicated by “Ends
in: x”, where x represents the seconds until completion.
‣
The pump will run at maximum pressure, forcing air and water from
the group and into the drain. Water will not dispense from the shower
screen.
‣
The program may not be cancelled once it has begun.
4. Once the program has finished, the first-level query, “PROGRAM MENU
Swipe Below”, will reappear. To continue menu navigation, swipe from left
to right. To exit menu navigation, move the brew actuator to the “pre-
brew” or “full brew” position.
Heater Control ON/OFF
The steam and brew tank heating elements may be activated or deactivated
independently. After completing the steps above to access the “Advanced
Setting” sub-menu, power on or off with the following steps.
To Next Page
Loading...
