Adjust Brew Tank Temperature
At the Slayer studio, the brew tank temperature is set at 93ºC (200ºF). Adjust the
brew tank temperature with the following steps.
1. Tap the round touch sensor near the center of the screen to activate the
menu.
2. Swipe from left to right until the “Brew Temperature” setting comes into
view.
3. Tap the round touch sensor to enter the “Brew Temperature” setting. “Up”
and “down” arrows will appear on the right side of the screen.
4. Use the arrows to adjust the brew temperature in tenth-degree (0.1-degree)
increments.
5. To confirm your new setting and continue menu navigation, tap the round
touch sensor. To confirm your new setting and exit menu navigation, move
the brew actuator to the “pre-brew” or “full brew” position. The new
temperature will be achieved and stable within 10 minutes.
Adjust Brew Pump Pressure
At the Slayer studio, the brew pump pressure is set at 9 bar. Actual brew pressure,
as indicated by the pressure gauge on the face of your machine, will be influenced
by incoming water pressure (line pressure) at your location. Adjust the brew pump
pressure with the following steps.
1. Tap the round touch sensor near the center of the screen to activate the
menu.
2. Swipe from left to right until the “Brew Pump Pressure” setting comes into
view.
3. Tap the round touch sensor to enter the “Brew Pump Pressure” setting. “Up”
and “down” arrows will appear on the right side of the screen.
4. Adjusting the brew pump pressure through the touchscreen interface is
accomplished by increasing or decreasing a percentage value that represents
brew pump pressure relative to maximum capacity. Use the arrows to adjust
the value in one-percent (1%) increments between “0” and “100”.
‣
To increase the pressure, increase the value.
‣
To decrease the pressure, decrease the value.
5. While still viewing the “Brew Pump Pressure” setting, set and test the pump
pressure with the following steps.
a) Grind, dose, and tamp and espresso as usual, lock portafilter in
grouphead, then move the brew actuator to the “full brew” position.
b) During "full brew", watch the brew pressure gauge and adjust the value
from step 4 until the desired pressure is achieved.
c) To confirm your new setting, tap the round touch sensor.
6. Reconfigure flow rate per instructions under “Using Slayer > Adjust Flow
Rate” on page 30.
To Next Page
Loading...
