1. Tap the touch sensor beneath “MONTH”. “Up” and “down” arrows
will appear on the right side of the screen.
2. Use the arrows to cycle options, pause on desired option, then
proceed to instructions for next setting: “DAY”.
•
The “DAY” setting determines the calendar’s day. Adjust with the
following steps.
1. Tap the touch sensor beneath “DAY”. “Up” and “down” arrows will
appear on the right side of the screen.
2. Use the arrows to cycle options, pause on desired option, then
proceed to instructions for next setting: “YEAR”.
•
The “YEAR” setting determines the calendar’s day. Adjust with the
following steps.
1. Tap the touch sensor beneath “YEAR”. “Up” and “down” arrows will
appear on the right side of the screen.
2. Use the arrows to cycle options, pause on desired option, then tap
the round touch sensor to confirm.
4. The “Set Time / Date” sub-menu will reappear. To continue “Advanced
Setting” sub-menu navigation, swipe from left to right. To exit menu
navigation, move the brew actuator to the “pre-brew” or “full brew”
position.
Set Power Saver On-Off Times
Slayer’s “Power Saver” program prompts the machine to toggle between “ready”
(heated for use) and “standby” (reduced power) per the user-input schedule(s).
Four (4) separate schedules are available for programming: two (2) per day for
weekdays (Monday through Friday) and two (2) per day for weekends (Saturday
and Sunday). This allows you to program Slayer to be ready for use in the
morning, after work, and so on. After completing the steps above to access the
“Advanced Setting” sub-menu, view the “Power Saver On-Off Times” sub-menu
and adjust the schedule with the following steps.
1. Swipe from left to right until the “Set Power Saver On-Off Times” sub-
menu comes into view.
2. Tap the round touch sensor to enter the “Set Power Saver On-Off Times”
sub-menu. “Up” and “down” arrows will appear on the right side of the
screen. The screen will first display the schedule for “MF1”, one of two
weekday power-saver programs. Inside the “MF1” schedule, the screen
will display two (2) settings: “START” (time of day) and “LENGTH” (time
duration). Your current selection is indicated by a pair of chevrons (“<
>”); unselected settings are indicated by pairs of square brackets (“[ ]”).
Adjust with the following steps.
1. Use the arrows to adjust the “START” value, pause on desired value,
then proceed to instructions for next setting: “LENGTH”.
‣
The “START” value indicates the time of day at which the machine
will be ready for use. Because the machine requires time to heat,
the actual time at which it exits standby and readies itself will be
earlier than this programmed value. Slayer will be ready to use at
or before the specified time.
To Next Page
Loading...
Need help?
General
