Step 8: Turn On Heating Elements
IMPORTANT: Before turning on heating elements, complete “Step 8: Calibrate
Steam Pressure Transducer” above. Failure to complete this step will result in steam
system malfunction.
Before beginning “Step 10: Turn On Heating Elements”, read “Navigating the Menu”
on page 18.
1. Per previous steps, ensure that the steam actuator is pulled forward, into the
“on” position.
2. Tap the round touch sensor near the center of the screen to activate the
menu.
3. Swipe from left to right until the “Advanced Setting” sub-menu comes into
view; swipe from right to left for immediate access.
4. Tap the round touch sensor to enter the “Advanced Setting” sub-menu.
5. Swipe from left to right until the “Heater Control” setting comes into view.
6. Tap the round touch sensor to enter the “Heater Control” setting. “Up” and
“down” arrows will appear on the right side of the screen.
7. Use the “up” and “down” arrows to toggle between “ON” and “OFF”; use the
round touch sensor to toggle between “BREW” and “STEAM”.
‣
Brewing and steaming functionalities may be used independently. For
faster warm-up, you may turn on only the element which heats water for
your desired function.
‣
Slayer’s brew temperature is most stable when the steam tank is hot. For
best performance, turn on both heating elements.
8. To confirm, tap the round touch sensor. To exit menu navigation, move the
brew actuator to the “pre-brew” or “full brew” position, then back to “off”.
The new temperature will be achieved and stable within 10 minutes.
‣
On the screen, a flashing colon will indicate heating element activity,
appearing near the brew temperature reading to indicate brew tank
heating and appearing near the steam pressure reading to indicate steam
tank heating.
9. The machine is heated when steam begins to flow from the steam wand; at
this point, move the steam actuator into the “off” position.
10.Lift to remove cup tray and check the inside of the machine for leaks or
collected water.
Step 9: Set Time and Date
During machine testing at the Slayer studio, machines are programmed to display
the local time and date in Seattle. After setup, you may reprogram the time and
date. Read “Navigating the Menu” on page 18 for help completing this step, then
complete the steps under “Using Slayer > Access Advanced Settings > Set Time /
Date” on page 38.
To Next Page
Loading...
Need help?
General
