Slayer Single Group - Adjust the Pre-Brew Timer with the Following Steps; Using Pre-Brew Timer; Access Advanced Settings

Adjust the pre-brew timer with the following steps.
1. Tap the round touch sensor near the center of the screen to activate the
menu.
2. Swipe from left to right until the “Pre-Brew” setting comes into view.
3. Tap the round touch sensor to enter the “Pre-Brew” setting. “Up” and “down”
arrows will appear on the right side of the screen.
4. Use the arrows to adjust the pre-brew timer in one-second (1-second)
increments, up to 30 seconds.
‣
“0” value disables pre-brew timer function
5. To confirm your new setting and continue menu navigation, tap the round
touch sensor. Moving the brew actuator will NOT confirm your new setting or
exit menu navigation.
Using Pre-Brew Timer
The pre-brew timer allows the barista to minimize brew actuator movement while
still making use of the pre-brew function. It can be activated, deactivated, and
programmed within the digital display; see instructions under “Using Slayer >
Adjust Pre-Brew Timer” on page 32.
Use the pre-brew timer to prepare espresso with the following steps.
1. Activate and adjust the pre-brew timer by following the steps under “Using
Slayer > Adjust Pre-Brew Timer” on page 30.
2. Grind, dose, and tamp coffee as usual, then lock the portafilter in the
grouphead.
3. Move the brew actuator to the "full brew" position to begin extraction. Slayer
will automatically initiate the pre-brew and full brew stages.
4. Allow the espresso to brew until the preferred extraction has been achieved
(when blonding occurs, when the desired beverage yield has dispensed, or
when the desired brew time has elapsed), then move the actuator to the
"off" position.
5. Remove the portafilter from the grouphead and knock out spent coffee. Wipe
the portafilter with a clean towel to remove grounds and oil.
6. Briefly move the brew actuator to the "full brew" position to purge grounds
and oil from the dispersion screen. Move the grouphead to the "off" position
and return the portafilter.
Access Advanced Settings
The “Advanced Setting” sub-menu has twelve (12) options. Access the sub-menu
with the following steps, then follow the individual instructions below.
1. Tap the round touch sensor near the center of the screen to activate the
menu.
32