3. To exit the “Slayer Info” page and continue “Advanced Setting” sub-menu
navigation, swipe from left to right. To exit menu navigation, move the
brew actuator to the “pre-brew” or “full brew” position.
Enter to reset
The reset program reboots the machine and reinitializes the software. This has
the same effect as unplugging, then returning the power source and is useful
when the plug is not easily accessible. After completing the steps above to
access the “Advanced Setting” sub-menu, begin the reset program with the
following steps.
1. Swipe from left to right until the “Enter to reset” program comes into
view.
2. Tap the round touch sensor to begin the reset program. A timer will
appear, count down from “30”, and the machine will power down.
‣
To cancel the reset program before the timer completes, tap the round
touch sensor.
3. Within several seconds, Slayer will reboot and normal operation may be
resumed.!
To Next Page
Loading...
