2. Tap the round touch sensor to select the “LENGTH” setting. An “END”
value will appear (top-right).
‣
The “LENGTH” value indicates the time duration for which the
machine will remain ready for use and is adjustable in 15-minute
increments.
‣
The “END” value indicates the time of day at which the machine will
enter the power-saving standby mode.
3. Use the arrows to adjust the “LENGTH” value, pause on desired value,
then tap the round touch sensor to confirm “MF1” schedule and
proceed. The screen will then display the schedule for “MF2”, the
second weekday power-saver program.
‣
If an “MF1” schedule is not inputted, the screen will not display the
option to create an “MF2” schedule.
3. Adjust the “MF2” schedule with the same procedure used for adjusting
“MF1”, then tap the round touch sensor to confirm. The screen will then
display the schedule for “SS”, the first weekend power-saver program.
4. Adjust the “SS3” schedule with the same procedure used for adjusting
“MF1” and “MF2”, then tap the round touch sensor to confirm. The screen
will then display the schedule for “SS4”, the second weekend power-saver
program.
‣
If an “SS3” schedule is not inputted, the screen will not display the
option to create an “SS4” schedule.
5. Adjust the “SS4” schedule with the same procedure used for adjusting
“MF1”, “MF2”, and “SS3”, then tap the round touch sensor to confirm.
6. The “Set Power Saver On-Off Times” sub-menu will reappear. To continue
“Advanced Setting” sub-menu navigation, swipe from left to right. To exit
menu navigation, move the brew actuator to the “pre-brew” or “full brew”
position.
7. Slayer will now toggle between “ready” (heated for use) and
“standby” (reduced power) per the user-input schedule(s).
8. At any time, you may exit the power-saving standby mode and initiate
normal heating by moving the brew actuator to the “pre-brew” or “full
brew” position. Slayer will temporarily exit “standby” and will be ready for
use in 10-15 minutes.
‣
If the programmed schedule still applies, Slayer will reenter “standby”
after one (1) hour of inactivity.
‣
This will disrupt the programmed schedule on this day only and will not
affect future programmed schedules.
Slayer Info
Your Slayer espresso machine’s serial number and software version may be
viewed on the “Slayer Info” page. After completing the steps above to access
the “Advanced Setting” sub-menu, view the “Slayer Info” page with the following
steps.
1. Swipe from left to right until the “Slayer Info” page comes into view.
2. Tap the round touch sensor to enter the “Slayer Info” page. The screen
will display your machine’s serial number and software version.
To Next Page
Loading...
