Pre-Brew
•
Timer that automatically engages “full brew” after specified time
•
Adjustable in one-second (1-second) increments
•
“0” value disables pre-brew timer function
To adjust the pre-brew timer, see instructions under “Using Slayer > Adjust
Pre-Brew Timer” on page 32. To brew with the pre-brew timer, see
instructions under “Using Slayer > Using Pre-Brew Timer” on page 33.
Advanced Setting
IMPORTANT: Most of the machine’s advanced programs and settings are set at
the studio to ensure optimal performance. Do not run or manipulate without first
reading this manual in its entirety, then – if unsure – consulting your Slayer
representative, reseller, or qualified service personnel.
•
Disable touch?
•
20-second touch sensor “sleep” used to safely clean display
•
Bleed Group
•
Automated bleeding program used to force trapped air from group
•
Heater Control ON/OFF
•
Independent control of power to brew and steam tank heating
elements
•
Temperature
•
Unit for temperature display: Fahrenheit or Celsius
•
Set PID Values
•
Algorithm parameters that assists in accurate water heating according
to saved settings
•
Brew Temp Offset
•
Value that assists in accurate brew temperature reading
•
Restore / Save Settings
•
Save User Settings: program that saves current machine settings as
user preferences
•
Restore User Settings: program that overwrites current settings and
restores user preferences
•
Restore Factory Tuned Settings: program that overwrites all user
preferences and restores Slayer-recommended settings; tunings
specific to your machine remain intact
•
Restore Factory Default Settings: program that overwrites all user and
Slayer preferences and restores hard-coded settings; tunings specific
to your machine are erased
•
Set Time / Date
•
Time and date setting and readout
•
Set Power Saver On-Off Times
•
Power-up schedule, including multiple power-saving stages per day
and separate weekend calendar
•
Slayer Info
•
Your serial number and software version
•
Enter to reset
To Next Page
Loading...
Need help?
General
