Procedure:
1. Complete “General Group Cleaning” steps 1-3 above.
2. Soak dispersion screw and screen overnight in a solution of hot water
and approved espresso machine cleaning powder. Later, rinse
thoroughly with clean water.
3. Install a clean, second set of dispersion screw and screen.
‣
CAUTION: failure to reinstall the dispersion screw and screen
before next use may cause the grouphead to clog with coffee
particles. Do not attempt to brew espresso before the dispersion
screw and screen have been correctly installed.
4. Remove the basket and portafilter spring from the portafilter and soak
overnight with the dispersion screw and screen. Later, rinse thoroughly
with clean water.
‣
CAUTION: do not soak portafilters with wood handles attached.
Exposure to water and/or chemicals may cause wood to crack or
warp.
5. Place the included blind insert in a portafilter, add approved espresso
machine powder, and lock in grouphead.
6. Tap the round touch sensor near the center of the screen to activate
the menu.
7. Swipe from left to right until the “Group Cleaning” setting comes into
view.
8. Tap the round touch sensor to activate cleaning program. A timer will
appear, count down from “5”, and the program will begin. As the
program runs, another timer will appear to indicate its progress,
counting down from “150”.
9. After cleaning program, follow prompt on screen, removing portafilter
from grouphead and tapping the round touch sensor to continue. The
group will begin rinsing automatically and a timer will appear, counting
down from “15”.
10.Follow prompt on screen, removing portafilter from grouphead and
tapping the round touch sensor to continue.
11.Remove blind insert from portafilter and use a clean, damp towel to
wipe oil and grounds from portafilter body.
12.Thoroughly rinse portafilter with clean, hot water.
13.Later, after soaking, reattach portafilter spring and basket and lock
portafilter in grouphead.
Steam Wand
After steaming milk, clean the exterior of the steam wand by wiping it
thoroughly with a damp towel, then clear its interior by briefly allowing steam to
flow.
If the steam wand tips clog, soak in hot water for several minutes, then briefly
engage steam with wand submerged. For tough clogs, use an approved espresso
machine steam wand cleaner.!
To Next Page
Loading...
