To Next Page

To Previous Page

6 Connection SMA Solar Technology AG

62 ClusterController-IA-en-10 Installation Manual

Changing the Display Languages via the User Interface of the Cluster Controller

You can only change the display language via the user interface of the Cluster Controller

1. Read out and write down the IP address of the Cluster Controller.

• Select the External communication display view.

• Read out the IP address from the IP Address line and write it down. Tip: if you wish to

integrate the Cluster Controller in a static local area network (LAN), you also require the IP

address for the network configuration (see Section 6.15).

2. Call up the IP address via the Internet browser.

☑ The login page opens.

✖ Does the login page fail to open?

Possible fault cause: you have not written down the IP address correctly or you have not

entered it correctly.

• Enter the correct IP address and confirm the entry with the Enter button.

• If the problem persists, read the troubleshooting (see Section7.2 "Faults in the

Cluster Controller or the Connected Devices", page70).

3. Select the desired language in the upper area of the login page.

4. Log in either as User or as Installer with the respective default plant password of the user

group. This implements the language change on the user interface and on the display:

User group Default plant password

User 0000

Installer 1111

Other manuals for SMA CLUSTER CONTROLLER

Questions and Answers:

Need help?

Do you have a question about the SMA CLUSTER CONTROLLER and is the answer not in the manual?

General