CHAPTER 3
USING YOUR DOCUMENT CAMERA
29 smarttech.com/kb/171225
Reducing glare
If glare makes it difficult for you to read the printed documents that you’re displaying, place the
anti-glare sheet on top of the documents.
Optimizing the image
To optimize the image for text documents
1. Set your document camera to Camera mode.
2. Press the MENU button on the control panel or remote control.
The OSD menu appears.
3.
Press the button on the control panel or remote control to navigate to the Image menu,
and then press the button on the control panel or remote control.
4.
Press the button on the control panel or remote control to navigate to the Mode sub-menu,
and then press the button on the control panel or remote control.
5.
Press the button on the control panel or remote control to navigate to Text mode , and
then press the button on the control panel or remote control.
To optimize the camera for documents with graphics
1. Set your document camera to Camera mode.
2. Press the MENU button on the control panel or remote control.
The OSD menu appears.
3.
Press the button on the control panel or remote control to navigate to the Image menu,
and then press the button on the control panel or remote control.
4.
Press the button on the control panel or remote control to navigate to the Mode sub-menu,
and then press the button on the control panel or remote control.
5.
Press the button on the control panel or remote control to navigate to Graphic mode ,
and then press the button on the control panel or remote control.
Using an SD/SDHC card
Your document camera has an SD/SDHC card slot on the right-side connection panel. You can save
To Next Page
Loading...
