IMPORTANT INFORMATION
ii smarttech.com/kb/171225
l Do not connect non-shielded interface cables to your SMART product and do no leave
cables connected to unused connectors, because this can cause interference level that
exceed FCC regulations.
l Avoid setting up and using the SMART product in an area with excessive levels of dust,
humidity and smoke.
l Do not block or cover the opening or slots on your SMART product. These slots provide
ventilation, ensure reliable operation and protect your SMART product from overheating.
l Do not carry your SMART product by the camera arm. Carry it by the base of the unit.
l Do not aim the camera lens at the sun.
l If your SMART product requires replacement parts, make sure the service technician uses
replacement parts specified by SMART Technologies or parts with the same characteristics
as the original.
l Ensure that batteries are stored in a cool and dry place.
l Do not discard batteries in water, fire, or domestic waste. Dispose batteries at collection
points.
l Remove the batteries in the remote control if you are not in for an extended period of time.
Battery corrosion or leakages can damage the remote control.
l Do not mix new and used batteries.
l Do not mix different types of batteries: alkaline, nickel-cadmium (rechargeable), or carbon-
zine.
Federal Communication Commission
Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause
undesired operation.
To Next Page
Loading...
