SMART Board 6065-V2 - Presence Detection Sensor

CHAPTER 1
WELCOME
6 smarttech.com/kb/171166
In normal operation, all buttons are white.
The Standby button also functions as an indicator light:
Indicator light Status Procedure
Solid white Normal operation [N/A]
Off Not receiving power
l
Confirm the display’s power cable is
connected to the power outlet.
l
Flick the switch beside the AC power inlet
to the ON(I) position.
Solid amber DPMS (power
management) mode
l
Press the Standby button to exit
DPMSmode.
l
Connect an input source.
Slowly flashing
amber
Standby mode
l
Press the Standby button to exit
Standby mode.
l
If presence detection is enabled, move in
range of the presence detection sensor.
l
If Wake to Touch is enabled, touch the
screen.
Flashing amber No USB connection from
the connected computer
l
Verify the connections to the computer.
l
Switch to the computer’s input.
See Using SMART Learning Suite on
connected computers on page12.
Slowly flashing
white
SMARTBoard service not
running on the connected
computer
Ensure that SMART Product Drivers is
installed and that the SMARTBoard
service is running.
Presence detection sensor
The display has a presence detection
sensor on its bottom frame that can detect
people up to 16' (5 m) away when the
display is in Standby mode.
When the sensor detects people in the
room, the display turns on. Touching the
screen activates the display. If the room is
empty for a specified period, the display
returns to Standby mode.