CHAPTER 2
GETTING STARTED WITH THE DISPLAY
13 smarttech.com/kb/171166
NOTES
l To interact with content, connect a USB cable to the appropriate USB Type-B receptacle on
the connector panel (as shown in the above diagrams).
l Your organization’s installers might have connected cables to the display or iQ appliance
and run the cables behind a wall or under the floor to a desk or table where you can place
your computer.
To view a connected computer’s input
If the computer is connected to the display, press the Input Select button on the front
control panel until HDMI1, HDMI2 or DisplayPort is selected.
OR
If the computer is connected to the iQ appliance, see Using Input on page30.
Interacting with content
By touching the display’s surface, you can do everything on the display that you can do at your
computer. You can also use an array of gestures within applications.
NOTE
Not all gestures work in all applications. Refer to an application’s documentation to learn which
gestures it supports.
Pan (one finger) Pan (two fingers) / scroll
To Next Page
Loading...
