HRX-OM-Q026-B
Chapter 3 Transport and Setting Up
3.3 Installation HRSH Series
3-14
3. Connect the power supply and the ground cable as shown in the figure below.
Fig. 3-8 Wiring of power supply cable
∗ Connect over current protection to the power cable connected to the equipment in order to avoid hazard.
Inlet of the power supply
cable
Note: Prepare a cable tie.
Fasten the power cable to the
mount on the base by the
cable tie.
View A
L1 L2 L3 PE
Mount for cable tie
To Next Page
Loading...
