SMC Networks JXC91

-23-
No.SFOD-OMT0006-F
5. External Connections
An example of standard wiring of the controller is shown for each connector.
5.1 PWR: Power supply connector
 Refer to 6. CN1: Power supply plug (P.25) for wiring.
Caution
Do not use an inrush current limited type of power supply for the controller.
5.2 MOT: Motor connector, ENC: Encoder connector
Connect the controller and the actuator with the actuator cable (LE-CP-)
5.3 SI: Serial I/O Connector
(1) Connecting the teaching box
Controller
Actuator cable
MOT
ENC
Actuator
Motor
Controller
PWR
Controller input power supply
24VDC
(The Controller power supply (24VDC) and wires must be prepared by the user.)
Wire
Controller
SI
Teaching box
(3m cable is provided)
Conversion cable