SMC Networks LECP6 Series User Manual

- 18 -
3.4 How to install
(1) How to install
The controller can be direct mounted using screws or mounted on a DIN rail.
The followings are the descriptions on how to install each type:
1) Screw mount type (LECP6□□-□) 2) DIN rail mount type (LECP6□□D-□)
(Installation with two M4 screws) (Installation with the DIN rail)
(2) Ground wire connection
Place the grounding cable with crimping terminal and toothed washer as shown below and tighten the
screw.
Caution
The M4 screw, cable with crimping terminal, and toothed washer should be obtained separately.
Ground the controller to shield it from electric noise.
If higher noise resistance is required, ground the 0V (signal ground).
When grounding the 0V, avoid flowing noise from the ground to the 0V.
Controller
M4 screw
Cable with crimping terminal
Toothed washer
Screw direction
Screw direction
Ground wire
DIN rail
DIN rail is locked.
Ground wire
Ground wire
A
Hook the controller on the DIN rail and
press the lever of section A in the arrow
direction to lock it.

SMC Networks LECP6 Series Specifications

General

Brand	SMC Networks
Model	LECP6 Series
Category	Controller
Language	English