- 8 -
2.3 How to Order
The part number construction for this product is as follows:
ＬＥＣＰ６Ｎ□□－□
Electric actuator model
Controller
Compatible
Number of step data
Parallel I/O type
I/O cable length Note 1) Specified software (LEC-BCW) is required.
Option
The controller and the electric actuator are factory set Confirm the combination of the
controller and the electric actuator is correct.
<Check the following before use.>
(1) Check the electric actuator label for the model number. Check that this matches the controller.
(2) Check Parallel I/O configuration matches (NPN or PNP)
Controller
(1) (1) (2)
Step motor (Servo / 24 VDC)
Stroke example: For LEFS25B-100B-S36N1,
specify LEFS25B-100.
Rotating angle: For LER10K-2L-R16N1D,
specify LER10K-2.
(Enter from the electric actuator part number “LE”
to “stroke/ rotating angle”)
To Next Page
Loading...
Need help?
General
