SMC Networks SMCGS10C-Smart User Manual

C HAPTER 4 | Configuring the Switch
MLD Snooping
– 145 –
This attribute will take effect only if MLD snooping proxy reporting is
enabled (see page 140).
◆ URI - The Unsolicited Report Interval specifies how often the upstream
interface should transmit unsolicited MLD reports when report
suppression/proxy reporting is enabled. (Range: 0-31744 seconds,
Default: 1 second)
WEB INTERFACE
To configure VLAN settings for MLD snooping and query:
1. Click Configuration, IPMC, MLD Snooping, VLAN Configuration.
2. Adjust the MLD settings as required.
3. Click Save.
Figure 55: Configuring VLAN Settings for MLD Snooping and Query
CONFIGURING MLD
FILTERING
Use the MLD Snooping Port Group Filtering Configuration page to filter
specific multicast traffic. In certain switch applications, the administrator
may want to control the multicast services that are available to end users;
for example, an IP/TV service based on a specific subscription plan. The
MLD filtering feature fulfills this requirement by denying access to specified
multicast services on a switch port.
PATH
Configuration, IPMC, MLD Snooping, Port Group Filtering
PARAMETERS
These parameters are displayed:
◆ Port – Port identifier.
◆ Filtering Groups – Multicast groups that are denied on a port. When
filter groups are defined, MLD listener reports received on a port are
checked against the these groups. If a requested multicast group is
denied, the MLD report is dropped.
WEB INTERFACE
To configure MLD Snooping Port Group Filtering:
1. Click Configuration, IPMC, MLD Snooping, Port Group Filtering.

SMC Networks SMCGS10C-Smart Specifications

General

Brand	SMC Networks
Model	SMCGS10C-Smart
Category	Network Router
Language	English

Summary

Warranty and Product Registration

About This Guide

Section I Getting Started

Introduction

Overview of switch features and management capabilities.

Initial Switch Configuration

Steps for connecting and performing basic configuration of the switch.

Section II Web Configuration

Using the Web Interface

Accessing and navigating the switch's web-based management interface.

Configuring the Switch

Basic configuration tasks for system information, IP, NTP, and logging.

Monitoring the Switch

Monitoring system information, CPU utilization, logs, and port status.

Performing Basic Diagnostics

Testing network connectivity using Ping and cable diagnostics.

Performing System Maintenance

Maintenance tasks: restarting, restoring defaults, and upgrading firmware.

Section III Appendices

Software Specifications

Lists the switch's supported software features, class of service, and management protocols.

Troubleshooting

Common problems and solutions for accessing the management interface and system logs.

License Information

Details the GNU General Public License terms for the product's software.