C
HAPTER
4
| Configuring the Switch
Quality of Service
– 175 –
3. Set the tag classification mode to Disabled to use the default QoS class
and DP level for tagged frames, or to Enabled to use the mapped
versions of PCP and DEI for tagged frames.
4. Click Save.
Figure 70: Configuring Ingress Port Tag Classification
CONFIGURING EGRESS
PORT SCHEDULER
Use the QoS Egress Port Schedulers page to show an overview of the QoS
Egress Port Schedulers, including the queue mode and weight. Click on any
of the entries in the Port field to configure egress queue mode, queue
shaper (rate and access to excess bandwidth), and port shaper.
PATH
Configuration, QoS, Port Scheduler
PARAMETERS
These parameters are displayed:
Displaying QoS Egress Port Schedulers
◆ Port – Port identifier.
◆ Mode – Shows the scheduling mode for this port.
◆ Weight – Shows the weight of each egress queue used by the port.
Configuring QoS Egress Port Scheduler, Queue Scheduler and Port Shapers
◆ Scheduler Mode – The switch can be set to service the queues based
on a strict rule that requires all traffic in a higher priority queue to be
To Next Page
Loading...
Need help?
General
