SMC Networks SMCGS10C-Smart User Manual

C HAPTER 4 | Configuring the Switch
Configuring Security
– 59 –
CONFIGURING THE
AUTHENTICATION
METHOD FOR
MANAGEMENT ACCESS
Use the Authentication Method Configuration page to specify the
authentication method for controlling management access through the
console, Telnet, SSH or HTTP/HTTPS. Access can be based on the (local)
user name and password configured on the switch, or can be controlled
with a RADIUS or TACACS+ remote access authentication server. Note that
the RADIUS servers used to authenticate client access for IEEE 802.1X port
authentication are also configured on this page (see page 77).
Remote Authentication Dial-in User Service (RADIUS) and Terminal Access
Controller Access Control System Plus (TACACS+) are logon authentication
protocols that use software running on a central server to control access to
RADIUS-aware or TACACS-aware devices on the network. An
authentication server contains a database of multiple user name/password
pairs with associated privilege levels for each user that requires
management access to the switch.
Figure 15: Authentication Server Operation
PATH
Configuration, Security, Switch, Auth Method
USAGE GUIDELINES
◆ The switch supports the following authentication services:
■
Authorization of users that access the Telnet, SSH, the web, or
console management interfaces on the switch.
■
Accounting for users that access the Telnet, SSH, the web, or
console management interfaces on the switch.
■
Accounting for IEEE 802.1X authenticated users that access the
network through the switch. This accounting can be used to provide
reports, auditing, and billing for services that users have accessed.
◆ By default, management access is always checked against the
authentication database stored on the local switch. If a remote
authentication server is used, you must specify the authentication
method and the corresponding parameters for the remote
authentication protocol on the Network Access Server Configuration
page. Local and remote logon authentication can be used to control
Web
RADIUS/
TACACS+
server
1. Client attempts management access.
2. Switch contacts authentication server.
3.Authentication server challenges client.
4. Client responds with proper password or key.
5.Authentication server approves access.
6. Switch grants management access.

SMC Networks SMCGS10C-Smart Specifications

General

Brand	SMC Networks
Model	SMCGS10C-Smart
Category	Network Router
Language	English