C
HAPTER
4
| Configuring the Switch
Configuring Security
– 63 –
â—† The following web browsers and operating systems currently support
HTTPS:
PARAMETERS
These parameters are displayed:
â—† Mode - Enables HTTPS service on the switch. (Default: Enabled)
â—† Automatic Redirect - Sets the HTTPS redirect mode operation. When
enabled, management access to the HTTP web interface for the switch
are automatically redirected to HTTPS. (Default: Disabled)
WEB INTERFACE
To configure HTTPS:
1. Click Configuration, HTTPS.
2. Enable HTTPS if required and set the Automatic Redirect mode.
3. Click Save.
Figure 18: HTTPS Configuration
FILTERING IP
ADDRESSES FOR
MANAGEMENT ACCESS
Use the Access Management Configuration page to create a list of up to 16
IP addresses or IP address groups that are allowed management access to
the switch through the web interface, or SNMP, or Telnet.
The management interfaces are open to all IP addresses by default. Once
you add an entry to a filter list, access to that interface is restricted to the
specified addresses. If anyone tries to access a management interface on
the switch from an invalid address, the switch will reject the connection.
PATH
Configuration, Security, Switch, Access Management
Table 5: HTTPS System Support
Web Browser Operating System
Internet Explorer 5.0 or later Windows 98,Windows NT (with service pack 6a),
Windows 2000, Windows XP, Windows Vista, Windows 7
Netscape 6.2 or later Windows 98,Windows NT (with service pack 6a),
Windows 2000, Windows XP, Windows Vista, Solaris 2.6
Mozilla Firefox 2.0.0.0 or later Windows 2000, Windows XP, Windows Vista, Linux
To Next Page
Loading...
Need help?
General
