SMC Networks SMCGS10C-Smart

C HAPTER 4 | Configuring the Switch
Quality of Service
– 177 –
2. Click on any enter under the Port field to configure the Port Scheduler
and Shaper.
Figure 71: Displaying Egress Port Schedulers
To configure the scheduler mode, the egress queue mode, queue shaper,
and port shaper used by egress ports:
1. Click Configuration, QoS, Port Scheduler.
2. Click on any of the entries in the Port field.
3. Set the scheduler mode, the queue shaper, queue scheduler (when the
scheduler mode is set to Weighted), and the port shaper.
4. Click Save.
Figure 72: Configuring Egress Port Schedulers and Shapers