C
HAPTER
4
| Configuring the Switch
Configuring the MAC Address Table
– 155 –
Figure 58: LLDP-MED Configuration
CONFIGURING THE MAC ADDRESS TABLE
Use the MAC Address Table Configuration page to configure dynamic
address learning or to assign static addresses to specific ports.
Switches store the addresses for all known devices. This information is
used to pass traffic directly between the inbound and outbound ports. All
the addresses learned by monitoring traffic are stored in the dynamic
address table. You can also manually configure static addresses that are
bound to a specific port.
PATH
Configuration, MAC Table
PARAMETERS
These parameters are displayed:
Aging Configuration
â—† Disable Automatic Aging - Disables the automatic aging of dynamic
entries. (Address aging is enabled by default.)
â—† Aging Time - The time after which a learned entry is discarded.
(Range: 10-1000000 seconds; Default: 300 seconds)
To Next Page
Loading...
Need help?
General
