C
HAPTER
5
| Monitoring the Switch
Displaying Information on Authentication Servers
– 221 –
DISPLAYING INFORMATION ON AUTHENTICATION SERVERS
Use the Monitor/Authentication pages to display information on RADIUS
authentication and accounting servers, including the IP address and
statistics for each server.
DISPLAYING A LIST OF
AUTHENTICATION
SERVERS
Use the RADIUS Overview page to display a list of configured
authentication and accounting servers.
PATH
Monitor, Security, AAA, RADIUS Overview
PARAMETERS
These parameters are displayed:
◆ IP Address – The IP address and UDP port number of this server.
◆ Status – The current state of the server. This field takes one of the
following values:
â–
Disabled – The server is disabled.
â–
Not Ready – The server is enabled, but IP communication is not
yet up and running.
â–
Ready – The server is enabled, IP communication is up and
running, and the RADIUS module is ready to accept access
attempts.
â–
Dead (X seconds left) – Access attempts were made to this server,
but it did not reply within the configured timeout. The server has
been temporarily disabled, but will be re-enabled when the dead-
time expires. The number of seconds left before this occurs is
displayed in parentheses.
WEB INTERFACE
To display a list of configured authentication and accounting servers, click
Monitor, Security, AAA, RADIUS Overview.
Figure 104: RADIUS Overview
To Next Page
Loading...
Need help?
General
