C
HAPTER
4
| Configuring the Switch
Configuring Port Connections
– 52 –
WEB INTERFACE
To configure the thermal protection:
1. Click Configuration, Thermal Protection.
2. Select the circuits which will use EEE.
3. Se the temperature threshold for each priority, and then assign a
priority level to each of the ports.
4. Click Save.
Figure 10: Configuring Thermal Protection
CONFIGURING PORT CONNECTIONS
Use the Port Configuration page to configure the connection parameters for
each port. This page includes options for enabling auto-negotiation or
manually setting the speed and duplex mode, enabling flow control, setting
the maximum frame size, specifying the response to excessive collisions,
or enabling power saving mode.
PATH
Configuration, Ports
PARAMETERS
These parameters are displayed:
◆ Link – Indicates if the link is up or down.
To Next Page
Loading...
Need help?
General
