To Next Page

To Previous Page

HAPTER

| Configuring the Switch

Quality of Service

– 182 –

◆ Ingress Classify – Specifies the classification method:

■

Disable – No Ingress DSCP Classification is performed.

■

DSCP=0 – Classify if incoming DSCP is 0.

■

Selected – Classify only selected DSCP for which classification is

enabled in DSCP Translation table (see page 184).

■

All – Classify all DSCP.

◆ Egress Rewrite – Configures port egress rewriting of DSCP values:

■

Disable – Egress rewriting is not performed.

■

Enable – Egress rewriting is performed without remapping.

■

Remap DP Aware – Frame with DSCP from analyzer is remapped

and remarked with the remapped DSCP value. Depending on the

frame’s DP level, the remapped DSCP value is either taken from the

DSCP Translation table, Egress Remap DP0 or DP1 field (see

page 184).

■

Remap DP Unaware – Frame with DSCP from analyzer is

remapped and remarked with the remapped DSCP value. The

remapped DSCP value is always taken from the DSCP Translation

table, Egress Remap DP0 field (see page 184).

WEB INTERFACE

To configure ingress translation and classification settings and egress re-

writing of DSCP values:

1. Click Configuration, QoS, Port DSCP.

2. Set the required ingress translation and egress re-writing parameters.

3. Click Save.

SMC Networks SMCGS10C-Smart User Manual

Other manuals for SMC Networks SMCGS10C-Smart