SMC Networks SMCGS10C-Smart User Manual

C HAPTER 4 | Configuring the Switch
Configuring Security
– 93 –
ACE CONFIGURATION
Ingress Port and Frame Type
◆ Ingress Port - Any port, port identifier, or policy. (Options: Any port,
Port 1-10, Policy 1-8; Default: Any)
◆ Frame Type - The type of frame to match. (Options: Any, Ethernet,
ARP, IPv4; Default: Any)
Filter Criteria Based on Selected Frame Type
◆ Ethernet:
MAC Parameters
■
SMAC Filter - The type of source MAC address. (Options: Any,
Specific - user defined; Default: Any)
■
DMAC Filter - The type of destination MAC address. (Options: Any,
MC - multicast, BC - broadcast, UC - unicast, Specific - user
defined; Default: Any)
Ethernet Type Parameters
■
EtherType Filter - This option can only be used to filter Ethernet II
formatted packets. (Options: Any, Specific (600-ffff hex);
Default: Any)
A detailed listing of Ethernet protocol types can be found in RFC
1060. A few of the more common types include 0800 (IP), 0806
(ARP), 8137 (IPX).
◆ ARP:
MAC Parameters
■
SMAC Filter - The type of source MAC address. (Options: Any,
Specific - user defined; Default: Any)
■
DMAC Filter - The type of destination MAC address. (Options: Any,
MC - multicast, BC - broadcast, UC - unicast; Default: Any)
ARP Parameters
■
ARP/RARP - Specifies the type of ARP packet. (Options: Any - no
ARP/RARP opcode flag is specified, ARP - frame must have ARP/
RARP opcode set to ARP, RARP - frame must have ARP/RARP opcode
set to RARP, Other - frame has unknown ARP/RARP opcode flag;
Default: Any)
■
Request/Reply - Specifies whether the packet is an ARP request,
reply, or either type. (Options: Any - no ARP/RARP opcode flag is
specified, Request - frame must have ARP Request or RARP Request

SMC Networks SMCGS10C-Smart Specifications

General

Brand	SMC Networks
Model	SMCGS10C-Smart
Category	Network Router
Language	English