Smipack S440 - Page 24

24
4 • Shrinking waiting time
Menu to adjust the waiting time between the sealing end and the heat-shrinking start. (value 0-1)
Fig. 4.6.4
It must be used with values different from 0 if there are problems due to the film tear along the
sealed side.
By using the keys and you increase or decrease the value by 0,1 units.
5 • Ejection time (S560N and S560NA)
Menu to adjust the packaged product ejection time. (value 0-10)
Fig. 4.6.5
By using the keys and you increase or decrease the value by 0,5 units.
If you set the value at 10, the belt flow will be delayed.
To be used for particularly high packets.
6 • Automatic cycle (S560NA)
Fig. 4.6.6
If you set this parameter at a different value than zero, the machine automatically carries out the
sealing cycles, without having to press the push-button START.
By using the keys and you increase or decrease the value (from 1 to 10).
By selecting 0, the parameter is not active.
By selecting a value different from 0:
- If you set 0,5, the bell will immediately descend, after the belt has stopped.
Start