Smipack S440 - Routine Maintenance; Nature and Frequency of Maintenance Checks and Operation

35
Use and maintenance manual S440-S560-S560N-S560NA-S870
7. ROUTINE MAINTENANCE
PRECAUTIONS DURING ROUTINE MAINTENANCE.
Before starting any maintenance operation, described in this chapter, unless otherwise
required, switch the machine off, switch the voltage off, acting on the main switch and
pull out the power supply cable from the mains.
7.1 NATURE AND FREQUENCY OF MAINTENANCE CHECKS AND
OPERATION
Tab. 7.1.1
DAILY MAINTENANCE CHART (12 HOURS OF WORKING)
BELL UNIT
CLEAN WITH A SOFT WET CLOTH
REMOVE THE FILM RESIDUES WITH COMPRESSED AIR
TANK UNIT
REMOVE THE FILM RESIDUES WITH COMPRESSED AIR
CLEAN THE BLADE WITH WARM WATER AND WITH THE SPRAY
SUPPLIED WITH THE MACHINE
SEALING UNIT
REMOVE THE RESIDUES OF FILM STUCK ON THE BLADE
BELT UNIT
(S560N-S560NA)
REMOVE THE FILM RESIDUES WITH COMPRESSED AIR
GENERAL CLEANING
TURN OFF THE MACHINE VOLTAGE.
CLEAN THE MACHINE WITH A WET CLOTH; AVOID THE MACHINE
COMING INTO CONTACT WITH WATER. IF YOU WET THE MACHINE
ACCIDENTALLY, DRY IT CAREFULLY, BEFORE STARTING PRODUCTION
AGAIN.
Tab. 7.1.2
WEEKLY MAINTENANCE CHART (60 HOURS OF WORKING)
SEALING UNIT
MAKE SURE THAT THERE ARE NO BREAKAGE ON THE CUTTING BLADE
COOLING UNIT
CHECK THE LEVEL OF THE COOLING LIQUID AND IF NECESSARY TOP
UP
Tab. 7.1.3
MONTHLY MAINTENANCE CHART (240 HOURS OF WORKING)
SEALING UNIT
MAKE SURE THAT THERE ARE NO BREAKAGE ON THE CUTTING BLADE
CHECK THE WEARING STATE OF THE PTFE UNDER THE SEALING BAR
AND REPLACE IT IF NECESSARY
Tab. 7.1.4
HALF-YEAR MAINTENANCE CHART (1500 HOURS OF WORKING)
SEALING UNIT
CHECK THE WEARING STATE OF THE CUTTING BLADE; IF NECESSARY,
CHANGE THE BLADE
CHECK THE INTEGRITY OF THE SEALING RUBBER
CHECK THE SPRING TIGHTENING
BELT UNIT
(S560N-S560NA)
MAKE SURE THAT THE BELT IS WORKING CORRECTLY
CHECK FOR ANOMALOUS NOISES
REPLACE POSSIBLE DAMAGED PARTS
AUTOMATISM UNIT
CHECK THE WEARING STATE OF THE COGGED BELT