89
Scope Multimeter Operations Operations
Figure 8-28 Sample Setup Units dialog box
Snapshot
The Snapshot tab of the Setup dialog box opens a window that allows you to select how much
data is captured after a snapshot is triggered (
Figure 8-29). Available selections, which range from
ten to ninety percent in ten-percent increments, are shown as buttons with the current setting
highlighted. Select a button, then select Back or Exit to close the dialog box.
Figure 8-29 Sample Snapshot dialog box
Refer to
Trigger Controls on page 83 for information on how to setup a trigger.
Abbreviation
Description
bar bar
inHg inches of mercury
kg/cm2 kilograms per centimeter squared
kPa kilopascal
mmHg millimeters of mercury
psi pounds per square inch
To Next Page
Loading...
Need help?
General
