98
Scope Multimeter Operations Operations
A Switch changes states when tapped with a finger or the stylus. Changes happen immediately as
the selection is made.
A dialog box opens as a separate window on the screen and typically includes a number of
choices. Changes happen immediately, however, the dialog box must be closed to return to the
main window and continue. Make a selection to close the dialog box.
9.2 Operations
This section describes configuring the scope or meter and performing tests. Selecting “View
Meter” from a Component Test or Scanner screen saves time by automatically configuring the
scope or meter.
9.2.1 Starting the Scope and Multimeter
Use the following procedure to set up the scope multimeter for performing tests.
z To start the scope multimeter:
1. Select the Scope Multimeter button on the VERDICT Home screen.
The Scope Multimeter main menu, a list of setup options, displays;
– Lab Scope
– Graphing Multimeter
– Digital Multimeter
– Presets
2. Tap to select the correct main menu option for the tests to be performed.
A submenu of scope or meter configuration displays, see below for additional information.
3. Tap to select the correct configuration for the tests to be performed.
The Scope Multimeter displays configured for the selected test.
Lab Scope Options
The following options are available for testing:
• 2 Channel Lab Scope
• Volts DC
• Low Amps (20)
• Low Amps (40)
• Ignition Probe
• 100 PSI Vacuum
• 100 PSI Pressure
• 500 PSI Pressure
• 5000 PSI Pressure
To Next Page
Loading...
Need help?
General
