Snom D735 - Conference; Initiating a conference

56
D735 User Manual Using the Phone
• In Fig. 4–6 there are two calls on hold. Fig. 5 and 6 both show the second held call, in short label
display mode (Fig. 5) and in full label display mode (Fig. 6). Press the function keys underneath
/ to show the call not currently on screen.
Fig. 4 Fig. 5 Fig. 6
• When the connected call is on-screen, you can transfer it to a third party or terminate it by
pressing
.
• When a held call is on-screen, press
to connect to it and put the currently connected call on
hold.
Conference
The maximum number of participants is three.
Note: This section refers to phone-based conferences. For the number of participants
and how to set up and participate in server-based conferences, please check with your
network administrator or your VoIP provider.
Initiating a conference
1. Call the first intended participant and put him or her on hold.
2. Call the second intended participant.
Fig. 1
3. Press to start the conference.
Conference screen navigation
Your input on the phone's keys will aect the caller/callee(s) or the entire conference shown in the
contact area of the display. Example: A conference with three participants, including yourself. After
you have pressed
(Fig. 1) to start the conference, the names, if available, and/or phone numbers
of the other participants are shown on-screen (Fig. 2 - 4). Fig. 2 shows the conference screen, i.e., all
of your conference partners while Fig. 3 and 4 show the screens for the individual participants.