socomec DIRIS Digiware C-31 Installation

5EN
DIRIS DIGIWARE DC - 545830B - SOCOMEC
2. HAZARDS AND WARNINGS
The term “device” used in this document covers DIRISDigiwareDC.
The assembly, use, servicing and maintenance of this equipment must only be carried out by trained, qualied
professionals.
SOCOMEC shall not be held responsible for failure to comply with the instructions in this manual.
2.1. Risk of electrocution, burns or explosion
Caution: risk of electric shock Ref. ISO 7000-0434B (2004-01)
Caution: refer to the accompanying documentation each time this
symbol is shown
Ref. ISO 7010-W001 (2011-05)
• Only duly authorised and qualied personnel may work or install/uninstall the device.
• The instructions are valid together with the specic instructions for the device.
• The device is designed only for its intended purpose as set out in the instructions.
• Only accessories authorised or recommended by SOCOMEC may be used in association with the device.
• Before starting operations of setting up, assembly, putting into service, conguration, cleaning, taking out of
service, disassembly, wiring or maintenance, shut down the power supply to the device and the installation.
However, in certain conditions, with certain means and subject to certain qualications and authorisations,
working on a live device may be prescribed by specic instructions.
• This device is not designed to be repaired by the user.
• For any questions related to the disposal of the device, please contact SOCOMEC.
• Failure to comply with the instructions of the device and this safety information can cause bodily injury, electric
shock, burns, death or damage to property.
Do NOT clamp or pull out NON-INSULATED conductors carrying DANGEROUS VOLTAGE which
could cause an electric shock, burn or arc ash.
Ref. IEC 61010-2-032
Failure to take these precautions could cause death or serious injuries.
2.2. Risk of damaging the unit
Caution: risk of electric shock Ref. ISO 7000-0434B (2004-01)
Caution: refer to the accompanying documentation each time this
symbol is shown
Ref. ISO 7010-W001 (2011-05)
To ensure that the unit operates correctly, make sure that:
• The unit is correctly installed.
• The auxiliary power supply voltage indicated on the product is observed: 24 VDC ± 10%.
• Use 230VAC/24VDC SOCOMEC or use a 1A 24VDC safety fuse.
• the maximum voltage authorised on the voltage input terminals.
• the obligatory connection to the DC current sensors using the recommended connection cables and observing
the maximum prescribed currents.
• Only use RJ45 SOCOMEC cables to interconnect the modules via the Digiware bus. When the ambient
temperature exceeds +50°C, the minimum temperature rating of the copper cable to be connected to terminal
must be +85°C.
Failure to respect these precautions could cause damage to the unit.

socomec DIRIS Digiware C-31 Specifications

General

Brand	socomec
Model	DIRIS Digiware C-31
Category	Measuring Instruments
Language	English