Wire EDM Machine Operation Chapter 9
Copyright November, 98 Page 9-8 Sodick Inc.
N021 T91 ( AUTO WIRE THREAD )
N025 G41 H062 (COMP LEFT AND .0062 OFFSET 1ST CUT)
N026 G51 A.5 (SET TAPER TO LEFT, .5 DEGREE)
N027 G12 (TURN OPTIONAL BLOCK SKIP OFF TO ACTIVATE GLUE STOP)
N028 T94 (SELECT SUBMERSE MODE FOR SUBMERSIBLE
MACHINES ONLY)
N029 T84 (TURN ON HIGH FLUSH PUMP)
N030 M98 P1000 (JUMP TO N1000 AND MAKE ROUGHING PASS)
N033 T85 (TURN OFF HIGH PRESSURE PUMP)
N035 C620 (SELECT CONDITION FOR STRAIGHT PORTION TRIM
PASS)
N040 G41 H053 (SELECT COMP LEFT AND .0053 OFFSET FOR
STRAIGHT PORTION TRIM PASS)
N043 G11 (TURN OPTIONAL BLOCK SKIP ON TO IGNORE GLUE
STOP)
N045 M98 P1000 (JUMP TO N1000 AND MAKE STRAIGHT
PORTION TRIM PASS)
N050 M02 (END OF MAIN PROGRAM)
(COUNTER CLOCKWISE SUB ROUTINE )
N1000 G01 X.485 (MOVE TO POINT 2)
N1005 Y.015 (MOVE TO POINT 3)
N1010 G03 X.5 Y0 I.015 (ARC IN TO POINT 4)
N1025 G01X.9 (MOVE TO POINT 5)
N1030 G03 X1. Y.1 J.1 (MOVE TO POINT 6)
N1035 G01 Y.4 (MOVE TO POINT 7)
N1040 G03 X.9 Y.5 I-.1 (MOVE TO POINT 8)
N1045 G01 X.6 (MOVE TO POINT 9)
N1050 G02 X.5 Y.6 J.1 (MOVE TO POINT 10)
N1055 G01 Y.9 (MOVE TO POINT 11)
N1060 G03 X.4 Y1. I-.1 (MOVE TO POINT 12)
N1065 G01 X.1 (MOVE TO POINT 13)
N1070 G03 X0 Y.9 J-.1 (MOVE TO POINT 14)
N1075 G01 Y.1 (MOVE TO POINT 15)
N1080 G03 X.1 Y0 I.1 (MOVE TO POINT 16)
/ N1085 G01 X.4 (MOVE TO POINT 17)
/ N1090 M00 (STOP TO APPLY MAGNETS, NOTE “/” CODE)
N1095 G01 X.5 (MOVE TO POINT 4)
/N1100 M00 (Stop To Remove Slug)
N1105 G03 X.515 Y.015 J.015 (ARC OUT TO POINT 18)
N1110 G01 Y.2 (MOVE TO POINT 19)
N1115 G40 G50 X.5 (CANCEL COMP ,TAPER & MOVE TO POINT 1)
N1120 M99 (END OF SUB ROUTINE)
Notes about the die program:
To Next Page
Loading...