Wire EDM Machine Operation Chapter 9
Copyright November, 98 Page 9-7 Sodick Inc.
Say you looked in the condition manual and found the conditions and offsets to be as
follows:
Rough pass (with taper) - C411 and H062
Trim pass (straight portion) - C620 and H053
Figure 9-3
NC Program for figure 9-3
N005 G54 (SELECT COORDINATE SYSTEM)
N010 G92 X.5 Y.2 (SET PROGRAM ZERO)
N015 G90 (SELECT ABSOLUTE MODE)
N020 C411 (SELECT CONDITION FOR ROUGH PASS)
To Next Page
Loading...