Wire EDM Machine Operation Chapter 11
Copyright November, 98 Page 11-3 Sodick Inc.
________________________________________________________________________
D) Multiplier for the off time (part of the adaptive control):
________________________________________________________________________
E) Peak Current
________________________________________________________________________
F) Capacitance
________________________________________________________________________
G) Voltage
________________________________________________________________________
12) Explain the first digit of MA.
________________________________________________________________________
The second digit?
________________________________________________________________________
13) If the table was moving too fast, and DC arcing was occurring, what would you do to
SF and/or SV to attempt to rectify the problem?
________________________________________________________________________
More On EDM:
14) Where do you go to find the specific Condition Numbers to machine a specific
material, thickness, with a particular wire diameter and number of trim passes?
________________________________________________________________________
15) What programming word (letter address) specifies the condition?
________________________________________________________________________
To Next Page
Loading...