SODICK A320D - Page 128

Wire EDM Machine Operation Chapter 11
Copyright November, 98 Page 11-8 Sodick Inc.
P
P
R
R
A
A
C
C
T
T
I
I
C
C
E
E
E
E
X
X
E
E
R
R
C
C
I
I
S
S
E
E
S
S
C
C
H
H
A
A
P
P
T
T
E
E
R
R
F
F
I
I
V
V
E
E
The Four Kinds Of Wire Motion
1) What is the G code for rapid motion?
________________________________________________________________________
Straight line cutting motion?
________________________________________________________________________
Clockwise Circular motion?
________________________________________________________________________
Counter clockwise circular motion?
________________________________________________________________________
2) When would you ever consider using a rapid motion in your program?
________________________________________________________________________
________________________________________________________________________
3) Name the machine related functions that will also occur when a straight line motion or
circular motion command is given:"
________________________________________________________________________
________________________________________________________________________
4) What does the word MODAL mean?
________________________________________________________________________
________________________________________________________________________
5) What are the two ways to specify circular motions?
________________________________________________________________________
________________________________________________________________________
Which is the way we recommend and why?
________________________________________________________________________
________________________________________________________________________
6) For the following drawing and program (on the following page), fill in the “blanks” to
complete the program.