SODICK A320D - Page 5

Wire EDM Machine Operation Table Of Contents
Copyright June, 98 Sodick Inc.
DAILY CHECKS 12-2
WEEKLY CHECKS 12-2
BI-WEEKLY 12-2
MONTHLY 12-2
QUARTERLY 12-2
ANNUALLY 12-3
MAINTENANCE DESCRIPTIONS 12-3
RESISTIVITY METER 12-3
DI BOTTLE: 12-3
WORKTANK AND TABLE: 12-4
WATER FILTERS: 12-4
CARBIDE POWER CONTACTS: 12-4
FLUSH NOZZLES: 12-5
WIRE GUIDES: 12-5
LOWER WIRE ROLLER ASSEMBLY: 12-5
WIRE EJECTION ROLLERS: 12-5
WAY LUBRICATION: 12-6
AUTOMATIC WIRE THREADER: 12-6
WIRE CUTTER: 12-7
LOW AND HIGH FLUSHING KNOBS: 12-7
RST BUTTON: 12-8
WIRE GUIDE ASSEMBLY DRAWINGS 12-9
FIGURE SHOWING LOWER HEAD ASSEMBLY 12-9
FIGURE SHOWING UPPER AWT HEAD ASSEMBLY 12-10
LOWER HEAD ALIGNMENT PROCEDURE 12-10
LOWER HEAD ALIGNMENT: 12-11
AWT ADJUSTMENTS AND TROUBLESHOOTING 12-11
AWT U AND V ALIGNMENT PROCEDURE 12-12
“SET” “MACHINE” SUBMODE SCREEN 12-12
WIRE SPOOL SETTINGS A350WP,A500WP, A600WP 12-16
AWT ELECTRICAL CABINET SETTINGS 350,500 ,600 12-17
CHAPTER 13 SET UP PROCEDURE CHECK LIST 13-1
CHAPTER 14 QUICK REFERENCE SECTION 14-1
POWER UP THE MACHINE 14-1
POWER DOWN THE MACHINE 14-1
REHOME THE MACHINE 14-1
MOVE AXIS BY “MDI” 14-2
INSTALL WIRE ON THE MACHINE 14-2
NOTES ABOUT INSTALLING WIRE: 14-2
AWT SPECIAL NOTE 14-3
MANUALLY ADJUST FLUSHING 14-3
EDGE FIND BY USING THE ST KEY 14-3
EDGE FIND (USING G80) 14-5
CHANGING THE AXIS DISPLAY READ ANY NUMBER 14-6
VERTICALLY ALIGN THE WIRE 14-7