Chapter 1 - Introduction
Copyright 2016 Softing Industrial Automation GmbH
11
1.4.2 Adapter Set for M12 Connection Technology
Using the M12 adapter set, you can connect the PROFIBUS Tester 5 to field devices with M12
connectors. The set comprises an M12 adapter cable with special pin layout and an M12 terminating
resistor that you can screw on, if required.
Figure 3: Special adapter set for M12
Softing Order No.: BC-600-PB-CB-M12
1.4.3 Fieldbus Shield Digital Leakage Current Clamp
When routing PROFIBUS cables in high-interference environments, electromagnetic interference can
affect the signal quality. By measuring the shield currents with the digital leakage current clamp, you
can locate EMC problem areas and take appropriate countermeasures. The digital leakage current
clamp is supplied in a handy case, including measuring cables. There is also an empty compartment for
the fieldbus shield digital leakage current clamp in the carrying case of the PROFIBUS Tester 5 (BC-700-
PB).
Figure 4: Fieldbus shield digital leakage current clamp
Softing Order No.: PB-LSZ-CHB3
1.4.4 Adapter for testing PROFIBUS PA networks
The optional plug-in adapter (including test equipment set) for PROFIBUS PA networks enables the BC-
700-PB to analyze electrical signal quality and data communication in PROFIBUS PA installations. The
BC-700-PB in conjunction with the adapter BC-700-H1 is the proper test tool for identifying basic
installation errors and defective PROFIBUS PA stations.
License for PA option
If you want to use the PA-Adapter BC-700-H1 with your BC-700-PB you need a
corresponding license (upgrade). This license is related to the serial number of your device.
When ordering the PA option we kindly ask you to provide us with the serial number of
your BC-700-PB (see also Licenses) .
Before using the PA adapter
Before using the PA adapter for the first time read carefully section PA-Adapter BC-700-H1
– before you start . Activate the PA license on your device and preform the required
updates.
To Next Page
Loading...