Softing PROFIBUS Tester 5 - Declarations by the Manufacturer

PROFIBUS Tester 5 (BC-700-PB) - User Manual
56
Copyright 2016 Softing Industrial Automation GmbH
14
Declarations by the manufacturer
This device complies to the EU product directive 2004/108/EC according to the following directives:
Reference number
Description
EN 55011:2009 +
A1:20102, Class A
Industrial, scientific and medical equipment - Radio-frequency disturbance
characteristics - Limits and methods of measurement, class A
EN 55022:2010, Class
A
Information technology equipment - Radio disturbance characteristics - Limits
and methods of measurement, class A
EN 61000-6-2:2005
Electromagnetic compatibility (EMC) - Part 6-2: Generic standards - Immunity
for industrial environments
EN 61000-6-4:2007 +
A1:2011
Electromagnetic compatibility (EMC) - Part 6-4: Generic standards - Emission
standard for industrial environments
EN 61326-1:2013
Electrical equipment for measurement, control and laboratory use - EMC
requirements - Part 1: General requirements
EN 50581:2012
Technical documentation for the assessment of electrical and electronic
products with respect to the restriction of hazardous substances
A Declaration of Conformity in compliance with the above standards has been made and
can be requested from Softing Industrial Automation GmbH.
CAUTION
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures!
ROHS
The PROFIBUS Tester 5 (BC-700-PB) device is ROHS compliant.
WEEE
Electrical and electronic equipment must be disposed of separately from normal waste at
the end of its operational lifetime.
Please dispose of this product according to the respective national regulations or
contractual agreements. If there are any further questions concerning the disposal of this
product, contact Softing Industrial Automation.
Note
To fulfill the EMC requirements, the other components (AC adapter, PROFIBUS stations,
etc.) also have to meet the EMC requirements. A shielded cable must be used. In addition,
the cable shield must be grounded properly.
Note
Additional tests have been performed successfully proving compatibility with the
requirements set forth by FCC and VCCI.